UAL 3
Dynamic load up to 5.100 N
Parallel design acme screw linear actuator. Timing belt drive to perform high linear speeds. Alluminium pulleys with low inertial enable faster acceleration and deceleration ramps. Preloaded angle ball bearings supporting the acme screw enable higher axial load capacity, higher linear speed, axial backlash free. Push or pull load. Lifelong lubricant, maintenance free. Housing in alluminim alloy. External tube in anodized alluminium and push rod in hard cromed steel tube. -------------------------------------------------------------------
Max load [N] 5.100
Max linear speed [mm/sec] 384
Standard strokes lenghts [mm] 100, 200, 300, 400, 500, 600, 700, 800
-------------------------------------------------------------------
Main features :
Rod diameter [mm] 35
Protective tube diameter [mm] 55
Motor flange European standard IEC 71 B14
Max static load - pull [N] 10.000
Max static load - push [N] 10.000
Actuator weight stroke 100 mm without motor [kg] 8
Additional weight each 100 mm 0,8
Duty cycle 30% over 10 min at 25°C room temperature.
3 timing belt drive ratios available.
7 different linear speeds available.
Acme screw 1 or 2 starts.
Lifelong grease lubricant for environmental temperature from -15° to +40°.
On request:
special execution for lower or higher environmental temperatures;
customized stroke lengths lower or higher than standard strokes;
push rod or protective tube in stainless steel;
rear fixing turned 90°.
-------------------------------------------------------------------
Input versions :
Motors with standard flange IEC 71 B14 with integrated assembling to the timing belt housing.
-------------------------------------------------------------------
Electric motors :
AC 3-phases 230 / 400 V 50 Hz IP 55 F, 2 or 4 poles, with ventilation system;
AC motor 1-phase 230 V 50 Hz IP 55 F, 2 or 4 poles with ventilation system;
DC motor 12 V or 24 V IP 54 F, without fan.
AC and DC motors available with or without brake.
AC motors in multivoltage executions can operate also at 60 Hz.
On request: special voltages, special wiring protections and insulations.
-------------------------------------------------------------------
Accessories :
Magnetic reed switches.
Front attachments: rod end, clevis end, ball joint.
Rear fixing bracket.
Encoder EH53, bideretional incremental encoder with 100 or 500 pulses per motor turn.
-------------------------------------------------------------------
|
Data Sheet |